Dedicated Micros Eco4 Operations Instructions download pdf (Page 33)

Eco4

Baud/Parity/Data/Stop/Flow Control

These options allow the Serial port communication settings to

be congured.

Note: When a telemetry protocol is selected, these settings will default to pre-determined values

and should not normally be altered.

Protocol This is a drop down list of serial telemetry protocols supported by

the unit.

Note: Refer to ‘Appendix F’ for a specication containing a full list of supported telemetry

protocols.

Reset (Red) Select to Reset the unit.

Maintain (Green) Select to open the System->Maintain page.

Camera (Blue) Select to open the Camera Conguration page (below)

Refresh (Purple) Refreshes the information on the current page.

Camera Conguration

This page allows conguration of some features on all 16 cameras available to the unit.

Title Titles assigned to each camera are displayed.

Mode The settings will default to ‘Colour’. If Monochrome cameras

are used, select ‘Mono’. Selecting ‘Mono’ will remove colour

patterning. If a particular channel is not in use or the camera has

failed, select ‘Not Connected’. ‘Remote Codec’ is used for NetVu

Connected video sources.

Term The unit will automatically terminate the camera input with 75Ω.

This should be disabled if the video feed is looped through to

another device.

Intelligent Security & Fire Ltd

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 139 140

No comments

Dedicated Micros Eco4 Operations Instructions Page 33